Nov 092009

my 95 intrepid is in limp mode. I have checked a few things and found there is no power coming off a light green wire at the trans controle module. That is the 12volt supply wire i checked this on a wiring diagram. Could this be a computer problem. I am able to apply voltage to this wire using a jumper from the battery and i can here the relay clicking on but still no shifting.

  One Response to “95 intrepid limp mode”

  1. Are there any trouble codes present?

    Here is how to check them if you have not done so:

    Sometimes a bad or failing VSS can cause this issue btu would check codes first.

 Leave a Reply