Serpentine belt replacement pulley tension
Thermostat Housing for 2017-2022 Chevrolet Colorado or GMC Canyon with the 3.6L engine. This repair took care of the check…
Removal & Installation Remove transmission. If original clutch cover will be reinstalled, mark position of cover on flywheel for assembly…
Engine has no codes. Scan tool shows cam and crank correlation are good. Fuel pressure from pump is at 60…
Headlamp Bulb R&R Warning: halogen bulb contains gas under pressure. bulb may shatter if glass envelope is scratched or if…
Intake CVVT came apart and blew a hole in the valve cover. How much would something like that cause to…
Hey everyone, I’m looking to upgrade the steering wheel on my BMW F30 and came across this option: Has anyone…
View Comments
Removal Procedure
•Remove the drive belt. Refer to Drive Belt Replacement .
•Remove the drive belt tensioner mounting bolt.
•Remove the drive belt tensioner.
Caution!
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Installation Procedure
•Install the drive belt tensioner.
•Install the drive belt tensioner bolt.
Tighten
Tighten the drive belt tensioner bolt to 50 N·m (37 lb ft).
•Install the drive belt. Refer to Drive Belt Replacement .