I recently purchased a 1997 Chrysler Sebring convertible with a 2.5l engine knowing it needed a fuel pump and filter. I replaced that and the… Read More »No start after replacing fuel pump Chrysler Sebring
Engine cranks but will NOT turn over. Changed battery, and got P1684-ECM reset code, no other codes follow. Check engine light flashes 5 times after… Read More »2003 Chrysler Sebring engine does not turn over
Originally, I had a code stating, out of time, crankshaft position sensor, and camshaft position sensor(total of 3). I changed the crankshaft sensor and cleared… Read More »Code P0340 2008 Chrysler Sebring 2.4L
I recently put a thermostat in my car. When I went to change it there wasn’t even one in it. So after I got one… Read More »Pressure 2005 Chrysler Sebring 2.7 gtc
driver door wont shut, mechanism stuck. how can I free the door to shut?
Low heat out of vents (80). Just did a motor swap not sure if all the air was bled out of system. All inside controls… Read More »05 Chrysler sebring sedan 2.7 v-6
Car won’t start. No fuel getting to engine. change relay change fuel filter and change fuel pump
on the block where the bottom radiator hose hooks up there is a tiny pin hole like the one in a water pump,only its on… Read More »2005 Chrysler sebring
the car will run for about 15 Minutes and then stall, I have 3 different people who have looked at it, some say its the… Read More »2000 Sebring JXI
What would cause the oil light to come on when the car is idling and go off when being driven? Oil is in the safe… Read More »2002 Chrysler Sebring