The switch will not operate door inside of dash that changes from heat to air conditioning! Can it be replaced without removing dash?
When the truck is cold and the idle speeds up, it makes the truck accelorate. If I put the truck in neutral, it drops down to a normal idle speed. Since this has started happening, I can notice the transmission shift timing is off and some sputter when in reverse or mashing on the gas. Anyone know these symptoms?
Just bought it, four dr with 52k miles, needed front brakes, front tires, front shocks which I just did to night. Took it out for a test drive and for the first time I really got on the gas . It has a terible vibration that resinates throught the whole truck when I kicked it down up to 60 mph until I let off.
When I drove it without kickin down the gas it was smooth, would this be broken motor or trans mounts or what???
Any help would be great!!!
SORRY TO AS AGAIN EVERY THANG CHECKS OUT HAVE GOOD GROUND BUT STEAL NOT GHARGE WERE WOULD I FIND THE BALLAST RESISTOR DOSE NOT SHOW ON MOTOR><THANK YOU 3.9 ENGINE
HOW DO I REPLACE THE BLOWER SENSOR. WHERE IS IT AND WHAT AM I LOOKING FOR?
4WD small V6 Cruise stopped working. A couple of small lurches when I tried to activate it and it was gone. Brake lights and horn still work. The lighted “cruise control” text does not come on when pushing button.. Everything else to my knowledge still works. I was told it wouldn’t be a fuse if horn and brake lights work. Where should I go from here? TIA
HAVE A (1987) DODGE DAKOTA>< NEW ALTERNATOR><NEW VOLTAGE REGULATOR><NEW BATTERY STILL WILL NOT CHARGE >< THANK YOU >< NEW STARTER TO !
I have a Dodge Ram 3500, 5.9L engine, 4×4, manuel transmission, with a heater blower motor working intermittently. It has now quit working. I have changed the heater blower motor and the heater blower motor resistor. It still does not work.
Is this a common problem as I have 2 friends with the same problem?
my 95 intrepid is in limp mode. I have checked a few things and found there is no power coming off a light green wire at the trans controle module. That is the 12volt supply wire i checked this on a wiring diagram. Could this be a computer problem. I am able to apply voltage to this wire using a jumper from the battery and i can here the relay clicking on but still no shifting.
Full of Oil, the dash light check guages, and oil pressure guage goes to zero. If you let up un the accelerator petal it stops. for a few minutes.