1993 Ford Ranger wiper switch replacement
What are the steps I need to follow to replace the turn signal / wiper switch arm? FYI-A mechanic already determined it was needing to… Read More »1993 Ford Ranger wiper switch replacement
2003 f250 O2 sensor fuse
The check engine light is on still after I replaced both bank 1 & 2 O2 sensors. Is there a bad fuse that is keeping… Read More »2003 f250 O2 sensor fuse
I have a 93 ford probe GT
When I start my car It idles around 1,000 rpms and when it tries to go past 2,000 rpms it jolts till the check engine… Read More »I have a 93 ford probe GT
2002 F250 7.3 diesel exhaust
Is it advisable to take out the muffler and replace it with a straight pipe. will this hurt or help the performance and/or gas mileage
88 ford bronco idle problem
88 Bronco, Check engine light comes on and idle varies from 500 to 1500 rpm. frequently stalls acts like it wants to backfire but doesn’t.… Read More »88 ford bronco idle problem
wont start
My 97 F-150 (4.6) won’t start. replaced battery and still won’t start. comp error states “camshaft position sensor”, I don’t understand. would this keep it… Read More »wont start
Ford Crown Vic PI 2003
1. Battery Light Comes ON/OFF At Random 2. Battery Electrolyte Spills. 3. System Volts High On Cold Engine 4. System Volts Low On Hot Engine.… Read More »Ford Crown Vic PI 2003
1999 Ford Expedition v8 5.4
this morning my expedition crank but wont start so it was send to the nearest mechanic.. Apparently was the fuel pump so they charge me;… Read More »1999 Ford Expedition v8 5.4
2000 Crown Vic P71 4.6 Ltr
Have a problem with tapping from the engine at high RPM’s. Seems ok while idling, and getting to speed is ok, but if i get… Read More »2000 Crown Vic P71 4.6 Ltr
overheating
97 ford f150 4.6l temp gage in normal range but no heat.gage goes to hot for abot 5seconds drops back to normal and then i… Read More »overheating