Front Brake Pad Replacement 2014 Subaru Crosstrek
My rotors, brakes or calipers are making this very high pitched noise but only have some time of driving, with the turn of the wheel,… Read More »Front Brake Pad Replacement 2014 Subaru Crosstrek
My rotors, brakes or calipers are making this very high pitched noise but only have some time of driving, with the turn of the wheel,… Read More »Front Brake Pad Replacement 2014 Subaru Crosstrek
I recently purchased a 1997 Chrysler Sebring convertible with a 2.5l engine knowing it needed a fuel pump and filter. I replaced that and the… Read More »No start after replacing fuel pump Chrysler Sebring
When driving in a bad snow storm should I leave the Positraction on full time or should I let the car turn it on when… Read More »Traction Control 2011 Ford Focus
How can I tell if my transmission blew in my truck or if its just a broken line? This is what happened… I drove my… Read More »Transmission fluid leak 2007 Dodge Ram 1500 4.7L Mag.
Needing a wiring diagram for headlights and front parking lights. The dim and parking light on passenger side do not have proper voltage to them… Read More »2006 Pontiac Torrent head light wiring diagram
My 2012 Nissan Versa currently has issues accelerating and when I make a stop the car refuses to move again. The code p0101 showed up… Read More »Nissan Code P0101 Mass Air Flow Sensor
This is specifically a question about the interior of the vehicle. My wife’s 2012 GMC Acadia front-wheel drive with a little over 71k miles. The… Read More »2012 GMC Acadia Radio Removal

A week ago I got my rebuilt transmission back from Monster Transmissions and finally got the bastard in and now its leaking transmission fluid from both coolant lines going into transmission. I have tried flaring new lines myself, but no luck…still leaking. Wtf could be going on? It wasn’t doing this pre-rebuilt. Thanks in advance
Make sure the lines are being inserted into the mounting inserts. If they are missing they will need to be replaced. If this are attached with quick disconnect lines, the plastic inserts may need to be replaced along with an o-ring seal. Did you have to use the Quick Disconnect tool 307-441 shown below?
Read More »Transmission lines are leaking 2007 Ford F150 5.4L v8 2wd
Hi All, I’m working on a 351 Cleaveland engine by Ford, and cannot move the distributor. I don’t need to remove it, just twist it… Read More »Distributor Stuck 1973 Ford Mach 1 Mustang
Engine burning oil This question is in regard to a 2006 GMC Sierra 2500HD (8.1L gas engine) with 197,000 miles on it. It had around… Read More »Fouling spark plugs and burning oil 2006 GMC Sierra 2500HD 8.1L