I don’t have power to my a/c compressor. I have power at the low pressure switch and power at the high pressure switch.
Must I remove the pulley in order to remove the power steering pump, or can the bolts be removed w/ the pulley staying on? The Haynes manual says that some require the pulley removed and some don’t. I’ve heard both ways from other sources too, I need help, please!?!
It wont start, has fuel to the engine, has good spark plugs and wires and cap and rotor, has a new distributor, has a new starter.
Why does my fuel pump stop working as soon as I hit the starter. The engine starts and runs for a couple of seconds and dies
Why does my left brake light only work when my right blinker is on?
What would cause anti freeze to leak from the heater vent onto the floor?
in 2-wheel drive transfer case sounds like its not all the way in gear makes a winding sound? this noise goes away when in 4-wheel drive hi or low range?
when replacing an inline fuel pump should the mechanic also replace the gas tank straps if he breaks them?
Is my tranny gone? It goes into reverse and drive but wont go any faster then 10-20 mph..
if the transmission pump goes out do you have to rebuild the transmission.