What is the wiring sequence (wire colors) from left to right when plugged in for the alternator pigtail?
If the timing belt breaks, how do you line up both overhead cams with the crankshaft for proper timing? I have the shaft on the mark and the right overhead cam on the mark but the left one isn’t.
I recently bought a 2002 Mitsubishi Lancer. The timing belt broke and has been replaced. I know this car has an interference engine and was wondering if you could tell me what I need to replace
We went to the car wash it ran and started just fine until we washed her. Went to pull out of washing station and got nothing but clicking. We pushed her to a position out of the way then we tried again and got nothing. We had a friend try to jump us but got nothing. There is power but not turning over. And after it sat for a while when we turn the key in the off position it makes a grind sound. We just recently replaced the back shock, brakes and windshield, and three out of the 6 spark plus only due the fact that we did not have the tools to get to the other three under the intake and plenum. We are changing the other three plugs as we speak but is there anything else that could be the problem?
i have take the fuel pump top off to put new seal (gasket) in and now the top will not go back on as it should what and where am i going wrong?
The engine is overheating after replacing the water pump and flushing the radiator.
I just replaced the alternator in my lancer now it is overheating. If I bypass the fusible link on my positive battery terminal the car runs fine but that fuse is tied directly to the alternator so it drains the batter when disconnected. My question is why is overheating when that fuse is connected and not overheating when I bypass it? Is the belt not tight enough or is the link bad on the terminal ?
My #3 injector is not pulsing. It has a wire ran straight from the injector to the computer. It worked for a little while and the wire was cut when the head was fixed and now it’s dumping gas again. The injector was replaced and I put another computer in it. What else could it be?
MY SPORT OPTION SHIFT DOES NOT WORK,WHAT IS A COMMON CAUSE FOR THIS AND WHAT IS THE ESTIMATE FOR REPAIR.
I just had the timing Chain done and it drove fine till I got home looked under the bonnet and oil is all over the engine and now I have no oil in it. Any help would be appreciated. Started to think it might be the oil sensor or switch.