put a 3 inch spacer in front end of my pickup and now is tight and grinding metal on metal against frame,what and how do i fix this ?
Jun 272015
Jun 262015
HOW TO CHANGE THE OIL SENSOR ON MY IMPALA SS
Jun 252015
Why would the steering wheel hard to the right when being driven. I have to keep a unusually tight grip on the wheel in order to keep it strait.
Jun 252015
Having to spray primer in throttle body in order to start..have replaced crank shaft censor,fuel pump..we have tested battery also…tested fire on spark plugs..im thinking its sometgin to do in throttle body…we have cleaned battery terminals also…plz help
Jun 222015
I am getting transmission fluid leaking into my motor. What could be causing this?
Jun 222015
where is oil sender located and how to test it?
Jun 192015
I have several lights staying on in my dash but yet no problems noticed. ABS and Brake lights, Battery light also. The Security alarm light comes on occasionally but usually goes off on next start up. No problems noticed with these lights on. This has been happening for about three months now. Also noticed is that the heat gauge doesn’t work at all and the AC doesn’t work either. Wiring and fuses have been looked at and no problems found. What is causing this?
Jun 182015
My truck miss fires and stalls after warm up . The rpms go up on it’s own trying to stay alive but stalls the temp. gauge goes up and down after warm. I’ve changed the thermostat cleaned MAF and throttle body still having the issue. Also when I throw into gear it stalls immediately.
Jun 172015
Why does my high beam indicator stay on constantly when the truck is OFF. I’ve found many complaints online about this problem and hope someone has figured it out by now. The indicator works fine as supposed to while the truck is running (only comes on with high beams on). When truck is turned off indicator come on after 15 seconds and stays on indefinitely. If any elect. circuit is used (open door,flip light switch,move the high beam signal, turn key, etc.) the indicator goes off then back on 15 seconds later if the truck isn’t started. All of my lights work properly on the truck,(every one of them) so it’s not a bad bulb issue for sure. I’m hoping someone knows what is going on since this is a common problem. Could it just be due to the recall on the cluster that was only available for 7 years or 70000 miles? The cluster does have bad readings on oil and volt readings. I’m tempted to take out the cluster and disconnect the indicator light just so it doesn’t drain the battery over time while not being driven.
Jun 162015
how to set per-load for front wheel bearings with ball bearing.